What does it mean by engine marking

Engine marking defines as the marking that must be set in order to get a good firing systems to make the engine starts.There are a few components involved such as timing bearing,timing belt,crankshaft pulley and timing belt pulley.

There are a few rules that must be followed to set the engine marking.

1) Must put the upper pulley mark accurately with distributor arm or rotor arm mark.
2) Must put the lower pulley mark accurately with the crankshaft mark.
3) When putting the timing belt clip make sure the upper pulley mark and the down pulley mark still at the same place so that the engine can easily start after installation.
4) Make sure putting the upper and lower timing oil seal properly to prevent any engine oil leaks.
5)Make sure upper pulley tighten properly and close it by timing cover.

Comments

Fuel Injectors: Time To Replace?

When it comes to squeezing out maximum fuel efficiency as well as power from your engine, properly working fuel injectors are an essential component to helping your vehicle run flawlessly. Eventually, however, like any part they do wear out. Fortunately, the selection of stock fuel injectors available on the market is wide; with a little research you can find replacement fuel injectors that are right for your car and at a price that is right for your wallet. Before you go to the expense of replacing your current fuel injectors, you should first check your fuel filter to see if it is the culprit. If clogged, replace the fuel filter and keep changing it every 25,000 miles. Gas prices are at all time record high levels, but you should only use name brand gasolines containing fuel injection cleaner additives to ensure continued good performance. In other word this could be done if you have more education on troubleshooting car problems and you could get it on this page, free knowledge ...

Troubleshooting engine overheating

Basically there are a lot of troubleshooting process of engine overheating.Before we go further we have to know the car components that works directly to overheating.The components consist of:- 1)radiator 2)radiator fan 3)water pump 4)thermostat 5)water hose 6)water jacket 7)cylinder head gasket These are the major components which always involved in an engine overheating.First is radiator,to ensure you will not facing such an overheating problem,radiator must contain enough coolant and absolutely clean from any leaks.Secondly radiator fan must actively working and makes no weird sound at all.Now thirdly water pump,you must make sure water pump still within the limit means it is still can be use without any pouring water from that component.(water pump located inside timing belt casing) Thermostat also one of contributors of overheating problems but it is very hard to know whether your thermostat is in good performing level if there is not temperature showing of engine ov...

Troubleshooting No-Start Vehicle Problems

There is nothing more infuriating than getting into your car only to find out that it would not start. As with other vehicle problems, the causes could range from a mere nuisance to major repairs. However, every driver must know the root cause of the problem and to give it a timely solution. Murphy’s Law describes all about such situations: whatever can go wrong will go wrong, and at the worst possible time. No start problem could happen when you are already late for work or the car is 200 degrees below zero out. Now, that makes you even more infuriated and you realize that indeed anything that can go wrong will go wrong. Troubleshooting no start problems would be easy if drivers know its causes. There are common causes and reasons behind the problem. The first reason is the failure of fuel pump failure or the restriction of fuel filter. This is the most prevalent cause of no-start problems in recent times. This is primarily due to the negligence of vehicle owners to enforce schedu...

Automotive Repair Information

Search This Blog